|
Standard
Features
Motor:
High-torque,
industrial, 1/2 HP, 115V, single-phase motor with instant
reverse and automatic reset thermal overload.
Door Lock
Sensor:
The adjustable Door Lock Sensor can detect if the door lock
is engaged and will stop the operator eliminating jamming
and damage to the door or operator. There is no longer any
need for wiring guide-mounted interlocks.
Wormgear
System:
Garage2Home´s reliable Wormgear System is utilized as the
primary level of reduction for the LGO. For a long cycle
life, gearing is pre-lubed at the factory with
high-performance grease.
Floor
Level Disconnect: Floor level disconnect provides
emergency manual operation.
Wiring Type:
B2 or D1 wiring
types are available. B2 wiring comes standard and is
pre-wired to accept photo eyes. This provides for momentary
contact to close with a 3-button control station (included).
D1 wiring is easily programmed and is designed to accept the
contact optional 2-button control station or 2-position
keyed control station for constant contact to open and
close.
Internal
Radio Control Receiver: Built-in Security+® Radio
Control Receiver with Smart Button technology. Transmitters
sold separately.
Positive
Locking Mechanical Brake System:
Efficient
commercial garage door opener self-locking mechanical reduction system that functions as a
holding brake.
Control Station: A Normally Open Stop Button
(N/O), 5VDC NEC Class 2 station is required. A 3-button
control station is included and allows for OPEN/CLOSE/STOP
functionality.
Control
Circuit:
24V NEC Class 2.
Control
Accessories and Options
Emergency
Egress Device:
Attractive faceplate
mounts flush on wall and contains pull handle to disconnect
operator from grille. Allows the door to be opened manually
or by spring tension. Flush handle or extended handle.
Sensing
Edge: (Addition of an auxiliary limit switch is
required for proper wiring of a sensing edge.) Designed
to sense an obstruction and signal door operator to stop or
reverse as desired. Either an electric or pneumatic sensing
device can be added to bottom edge of door. Allowable in
either B2 or D1 wiring. Order part number 90-LGOSE for the
LGO Safety Edge Kit.
Radio Control:
Universal
transmitters are available to signal the operator for
OPEN/CLOSE/STOP functionality. 1-, 2-, 3- and 4-button
transmitters and keypads are available.
CPS®
Commercial Protector System: (Recommended) An
inexpensive "non-contact" photo safety sensor designed to
sense an obstruction and signal the commercial garage door
opener to reverse
to open.
- Safety of a
non-contact infrared reversing sensor
- Fast and
easy-to-install
- Patented
electrical interface monitors system status at all times
- LED indicators
for quick alignment
- One size fits
all (for doors up to 30 ft. wide)
- Requires D1,
C2 or B2 wiring type
|
